RENNtech HSM
Hand-Held Suspension Module
W222 | C217 | S-Class
Hand-Held Suspension Module
W222 | C217 | S-Class
An awesome new product from RENNtech Mercedes, HSM Modules for the W222 / C217 S class. Instead of having only a basic OBD2 configuration with pre-loaded height adjustment, you can now fine tune using a tablet or similar. This allows you to adjust for any ride height adjustment you need based on driving styles, road conditions, comfort level ect. Innovation and technology have always been a strong point for RENNtech. Check out the specs below or email one of our specialists for inquiries [email protected]
| 32.222.6001 |  |
RennTech Hand-Held Suspension Module Mercedes Benz S500 W222 14-16 | $1,495.00 |  |
The RENNtech Hand-Held Suspension Module (HSM) is designed to work with the W222 – S-Class Sedan and C217 – S-Class Coupé/Cabriolet, equipped with the Mercedes ABC Hydraulic Suspensions. The unit allows the user to have full control over all four corners of the vehicle’s suspension and adjust in 1mm increments.
The HSM comes pre-loaded with a RENNtech lowering setting. User can load their custom setting onto the HSM to set the vehicle to their preferred ride height.
The desired lowering setting will be loaded onto the vehicle via the ODB2 port in the footwell of the car. After plugging the HSM into the ODB2 port, the user can toggle a switch to load the factory or the adjusted ride height. After a few seconds, the new setting is uploaded and the car will adjust to the new height.
The factory setting will always be stored on the HSM and the user can set the vehicle back to the factory setting.
Once the settings are loaded, simply unplug and store for future use.
All RENNtech HSMs are adjustable via USB using either Windows or Android OS. The software allows the user to adjust the ride-height at each corner in 1mm increments independently. The software also has three locations where the user can store pre-configured suspension setups for quick changes.
• Pre-loaded with a RENNtech optimized setting
• Fully adjustable with the RENNtech Suspension Software
• Custom setting loaded onto suspension module via USB
• Lower and raise your car through the ODB2 port within seconds
• Full Installation time 10 seconds
