See more parts for your BMW 316i

Brey Krause Harness Mount Bar BMW E36 Coupe M3 92-98 | 3-Series 92-98

$529.20

Brey Krause

Model #R-1201

In Stock

Help me decide

Shopper Award

The E36 harness mount bar has been tested and certified by an independent lab to handle the types of forces required by the National Highway Traffic Safety Admin. DOT and SAE J385 Rev. MAR 95, Motor Vehicle Seat Belt Anchorages-Performance Requirements. The E36 harness mount bar properly locates and supports racing shoulder harnesses relative to the driver. In the case of an accident, it helps protect the drivers shoulders and spine. The harness guides also prevent excessive shifting and fatigue of the driver during the high G loads of cornering and braking. Our bars are easy to install and remove, use only existing holes and mounting points, and will not damage the car in any way.

Strength requirements for harness mounts are considerably greater than those for harness guide bars since they must support the entire load applied to the belts. Bar is mounted to the rear side lap belt mounting points via brackets that are installed once and remain in the car. Support rods are attached to the ends of the main tube while the other end attaches to car at the front lap belt mounting points located at the door sills. Bar is designed to allow enough seat travel for tall drivers. After initial installation the bar can be removed and reattached in about 15 minutes. (Seat brace kit available soon.)

Proposition 65

/!\ warningWARNING: Cancer and Reproductive Harm

https://www.P65Warnings.ca.gov

Vehicle Engine Notes
1992-1998
BMW 316i

1992-1998
BMW 318i

1992-1999
BMW 318is

1992-1998
BMW 318tds

1995-1999
BMW 318ti

1993-1995, 1998
BMW 320i

1992-1998
BMW 323i

1998-1999
BMW 323is

1999
BMW 323ti

1993-1998
BMW 325i

1992
BMW 325is

1992-1998
BMW 328i

1996-1999
BMW 328is

All products manufactured by Brey-Krause Mfg. Co. are warranted to the original purchaser to be free of defects in material and workmanship for a period of one year from the date of purchase. This warranty is limited to the replacement or repair of defective items returned to Brey-Krause Mfg. Co. in good condition.

All Brey-Krause mirrors are subject to the above warranty terms. In addition, Brey-Krause mirrors are warranted for the period of 10 years against silver spoilage from the date of manufacture.

Check out these other great products