Driveshaft Shop Aluminum Driveshaft Subaru Impreza RS Manual 99-01
This is a 3" Aluminum single shaft for all the Subaru platforms. These shafts are in some of the fastest Subarus around the world including Easy Streets WRX and Big Valleys STI. the shafts do have some clearance issues so the floor will need to recontoured a little (some floor braces flattened along with the floor you must have 3/4" clearance all the way around the shaft in every area) these shafts are designed for street use but may also be used for racing, so DSS needs to advise you the shaft has a 600WHP max and a critical speed of 150mph. These shafts have had more than both put into them but these are the recommended limits. This shaft is less than half the weight of the factory 2 piece and by eliminating the hanger will remove the lag the factory shaft has when the hanger moves up and down. Comes with 1 year warranty.
Note: 150MPH Max.Please Note:
All aftermarket driveshafts might be slightly larger than factory specs therefore minor clearance might need to be cut or cleared in the driveshaft tunnel. Driveshaft should have a minimum of 1/2" clearance for proper use.
For the past 30 years, Driveshaft Shop has designed many of the driveshafts used in numerous record setting race cars. Vivid Racing carries driveshafts in aluminum, steel, chromoly and now carbon fiber so we can design a solution that fits your needs. Each driveshaft produced is dynamically balanced at over 9000 RPMs to ensure unbeatable reliability. If you need a custom part, give us a call. Vivid Racing can help setup your car with the proper driveshaft or axle from Driveshaft Shop.