What good is more horsepower if it isn t transferred to the ground? The clutch is the main link between the power your engine produces and the transmission, but all too often it is also the weak link. Many stock clutches simply will not last under harsh driving conditions or continual hard launches. When a car is making more horsepower than stock the factory clutch is under even more strain. This can cause premature clutch wear and costly repair bills. Spec Clutch solves this problem with their line of performance clutches. With increased surface area Spec clutches give your transmission more bite while increasing reliability and performance. High clamp pressure plate.Carbon-Graphite Friction Material.High torque solid hub and disc assembly. (application dependent)Includes bearing and tool kit. (application dependent) These clutch kits are designed for use with SPEC flywheels or any aftermarket LS1/6 single mass flywheel, which bolt to the LS7 and offer a considerable reduction is rotating mass. These kits increase friction surface diameter to 12inches while reducing rotating mass by up to 36%. The SC57 flywheels are for use with non-stock clutch designs. For a flywheel to be used with the OE style clutch, use pn SC66A-2 or SC66S-2. The package includes race bolt kit, pilot bearing and alignment tool. This application does not utilize a conventional throwout bearing, as the releaser is a concentric hydraulic slave/bearing assembly. This concentric slave is available as an option to the kit.
Applications: Street, Drag, Pulling, Autocross. This unit is a solid hub version of the stage 3. The hub is solid 8-rivet and the assembly is heat treated for strength and durability. It is available in a 3, 4 or 6 puck configuration. Use the 3 puck for the lightest option or the 6 puck for the smoothest engagement. The 4 puck is a good compromise for both. Street drivable in 6 puck configuration, but not street friendly due to the rigid hub. Best for drag racing, road racing, pulling, rally and drift.
Chevrolet Corvette LS7 06-09
S.P.E.C., Inc warrants all products to be free of defects in materials and workmanship for normal use and service up to 120 days after retail purchase. SPEC reserves the right to examine any part returned for warranty claim to determine whether a defect in materials or workmanship exists in such product. SPEC liability is limited to repairing, replacing or crediting towards other product, and credits will not exceed the invoice total for the parts. Labor and storage charges are not products of SPEC and, therefore, will not be reimbursed for any reason. Final determination of the condition and suitability of the parts for uses contemplated by the buyer is a sole responsibility of the buyer. SPEC will not be liable for any damage or injury to persons or property that might be claimed as a result of improper installation or misuse of any part subject to this warranty. Return shipping to SPEC will not be pre-paid or paid for. Customer is responsible for return shipping for inspection. There are no warranties expressed or implied beyond those set forth above.