The Planted Seat Bracket is a vehicle specific bracket used as an adapter between the floor of the vehicle and an aftermarket seat and it's accessories. Because the floor of each vehicle varies and typically is not flat, a vehicle specific Seat Bracket is required for installing an aftermarket seat. We create each seat bracket using the floor of the vehicle as a reference. We literally bring each vehicle into our development center so we can create the best fitting, bolt in, universal seat bracket possible.
Planted Seat Brackets are laser cut from 3/16 inch thick steel and hand welded to ensure weld penetration for superior strength. Each bracket is pre-slotted with hole patterns to accept sliders from most major seat manufacturers like Braum, Bride, Cipher Auto, Cobra, Corbeau, Momo, NRG, OMP, Racetech, Recaro, Sabelt, Sparco, Status Racing, Takata and more. There is extra space on the bracket for drilling your own hole pattern if using a slider with a less common hole pattern, or direct mounting a seat or side mount when eliminating sliders is preferred. They are finished with a black powder coat and applications are available for many vehicles.
3/16" Steel, Black powder coating
Extra material provided to eliminate seat slider
Each Planted Seat Bracket goes through three levels of quality control to ensure high standards are met
Seat Sliders NOT included
Welded in Bellevue, Washington, USA
Mazda RX-7 1992-2002
Seats come in many different shapes and sizes so not all seats will fit in all vehicles. It is up to the end user to determine if the seat will fit prior to ordering the Seat Bracket and other components.
Many vehicles have the steering wheel offset toward the center of the vehicle. This can be accentuated when installing an aftermarket seat of a different size then the factory seat.
Replacing a factory seat with an aftermarket seat may cause the vehicle's warning indicators to activate. This can be due to airbag, weight and/or other sensors in the factory seat that are not included in an aftermarket seat. It may be possible to eliminate these indicators with an electronic resistor but it is up to the end user to determine if a resistor will work & which resistor to use.
We are a family owned company with a passion for modifying all types of vehicles from the old vintage ride to the newest driving machine. In our fabrication shop we build custom roll cages and do full car builds. It's out of this fabrication shop we discovered the need for a stronger, higher quality, more versatile, more available seat bracket for mounting aftermarket seats... Planted Technology was born. Over the years we've grown our applications offered whenever possible and developed many accessories to go along with the Planted Seat Bracket. We're always looking for new applications and products to develop as well as ways to improve our current products.