Add more comfort and containment to your Can-Am X3 or Maverick R with PRP's most popular suspension seat! With 7 inch of containment and just the right seating angle, the GT/S.E. Suspension Seat keeps you contained and comfortable while off-road.

Medium level containment on the sides keeps you secure when the ride gets rough, but still makes it easy to get in and out of the vehicle. Our standard mesh drain allows water, mud, and dirt to drain out the bottom, rather than pile up in the seat.

The vinyl-coated nylon suspension liner and dual-density foam decreases the impact on the body, reducing the fatigue you feel after a long day in the dirt or dunes. Constructed from durable and water resistant vinyl, so it's easy to clean after a weekend of getting dirty and dusty. Improve your ride! Upgrade to the most popular aftermarket Can-Am suspension seat!

PRP's Seat Mount and Slider Kit the Can-Am Maverick X3 and Maverick R allow you to install your favorite PRP Seats into your UTV. Rather than just a simple adapter mount this is an entire new rail system with more height adjustments, and includes our dual locking seat sliders.

A common complaint on the X3 is that the seat sliders start to get stuck after dirt and dust gets into the wheels. So we've added in our own slider kit that has been tried, tested, and proven over the last 20 years in all sorts of off-road environments. Our dual locking sliders provide more security and stability.

Both the right and left sides of the sliders have locking mechanisms to keep them in place during hard impacts. These seat mounts allow an enhanced range of adjustability, allowing the seats to get as low as they can possibly go. You have the ability to set the height and depth of the mounts to get the perfect position each rider. Creating better comfort, and confidence behind the wheel. The flat base mounts are lower than the stock rails, and have an offset mounting point in the front.

So you can flip the mounts down if you want to be lowered an inch, or flip them up if you want to raise the seat height an inch. The mounts use the existing mounting points in the cab, which allow you to raise or lower the seat in the front and back to adjust the seating angle.

At the lowest settings with the mounts flipped down, you can sit about 3 inch lower. This mount is perfect those with lowered cages.. Maverick R owners this the only mount that we recommend using in the front.

The passenger side of the Maverick R has a glove compartment that sticks out farther, making it harder taller passengers to fit comfortably.

This seat mount and slider kit allows you to adjust seat farther back, and adjust the recline angle to get more legroom on the passenger side.

However the Rear of a Maverick R MAX you must use our standard C86 Can-Am adapter mount, as the rear sliders are a differnt design. This kit comes with 2x GT/S.E. Seats, and the C91 Can-Am Mount and Slider Kit (Pair) FITMENT: Can-Am X3 Can-Am X3 MAX (Front and Rear)


Fitment:

• Can-Am Maverick X3 | Maverick R